Maxx Ice MIM50 Instrukcja Użytkowania i Eksploatacji Pobierz pdf (Strona 23)

6. Plug in the ice maker or reconnect power.

Water distribution tube cleaning

When you find the ice cubes are incompletely formed or the output is low, the water

distribution tube may be blocked. Turn off the power button, rotate the water distribution

tube, locate the holes in the distribution tube and use a pointed object such as a toothpick

to dredge the holes. Then rotate the water distribution tube back to its original position. If

the tube is badly blocked, clean it as follows:

1. Shut off the water supply

2. Disconnect the water hose from the distribution tube.

3. Lift the right side up, then remove the distribution tube.

4. With a brush, clean the tube with a dilute solution of warm water and a mild detergent

such as dishwashing liquid. After removing the dirt and lint from the surface, rinse the

tube with clean water.

5. Replace the distribution tube.

6. Reconnect the water supply.

Control panel:

DO NOT touch the condenser fins. They are sharp and can be easily damaged.

The ice machine cleaner contains acids.

DO NOT use or mix with any other solvent-based cleaner products.

Use rubber gloves to protect hands. Carefully read the material

safety instructions on the container of the ice machine cleaner.

Discard the first batch of ice produced after cleaning.

1 2 ... 18 19 20 21 22 23 24 25 26 27

Brak uwag

Maxx Ice MIM50 Instrukcja Użytkowania i Eksploatacji Strona 23