Maxx Ice MIM50 Instrukcja Użytkowania i Eksploatacji Pobierz pdf (Strona 14)

into the drain line.

NOTE: Never allow the drain hose to hang or loop higher than the floor of the ice storage bin.

Screw off the water drainage nut and pull off the plug on the rear of the ice storage bin.

NOTE: Store the drainage nuts and plugs in the compartment labeled Nut/Plug Storage at the back of the unit

or in another safe place.

All horizontal runs of drain lines must have a fall of ¼” per foot. An air gap will likely

be required between the ice maker drain tube and the drain/waste receptacle. A stand

pipe with a trap below it would be acceptable for the drain/waste receptacle. A floor

drain is also acceptable. If this is not possible, Maxx Ice recommends the use of a

condensate pump. Contact Asbury Service Warranty & Parts at 1-877-368-2797.

4. Pour 1 gallon of water into the ice storage bin to check for leaks at all drain

connections and at the nut of the drain water hole. Tighten any connections or nuts that

leak.

NOTE: This ice maker is not a freezer. Hot temperatures will cause a high rate of melting in the ice storage bin.

Installation Types

This ice maker has been designed for Mobile (free-standing) installation. However, it can

also be enclosed (under a cabinet) or Built-in (sealed to the floor). In every case, there

must be adequate air space around the unit for ventilation.

Mobile installation:

A mobile installation will allow you to install the ice maker free-standing in any place you

desire provided you have access to a water supply. You must follow the stated instructions

for:

a. Electrical requirements

b. Water supply

c. Leveling the ice maker.

Enclosed Installation:

An enclosed installation will allow you to install the ice maker under a cabinet or in a

kitchen cabinet provided the required clearance space around the ice maker is respected.

This installation has the same requirements as a mobile installation.

Built-in installation:

If this method of installation is chosen, it will still be necessary to allow adequate

ventilation space around the unit. The following additional items must be observed.

1. Place ice maker in front of installation location. Remove the feet and place the unit flat

on the floor or on a platform depending on your installation requirements.

2. The water supply line must be plumbed before connecting to the ice maker.

3. Turn on main water supply and tap. Check for water supply connection leaks. Tighten

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

Brak uwag

Maxx Ice MIM50 Instrukcja Użytkowania i Eksploatacji Strona 14