Maxx Ice MIM50-O Instrukcja Użytkowania i Eksploatacji Pobierz pdf (Strona 19)

TROUBLESHOOTING

Before Calling for Service

If the unit appears to be malfunctioning, read through the OPERATION section of this

manual first. If the problem persists, check the Troubleshooting Guide below and on

the following page. The problem could be something very simple that can be solved

without a service call.

Problem Possible Cause Probable Correction

The machine

does not operate.

The icemaker is unplugged.

The fuse is blown.

The Power switch is set at

OFF.

The ice storage bin is full of

ice.

Plug the ice maker in.

Replace fuse – if this hap-

pens, call for service to

check for a short circuit in the

ice maker.

Turn the Power switch to ON.

Remove some ice, making

sure the ice-full probe is free

of ice.

The water doesn't feed in

after the machine starts.

The water supply tap is turned

off.

The water supply line is not

properly connected.

Turn on the water supply tap.

Reconnect the water supply

line.

Machine makes ice, but ice

storage bin does not fill up

with ice.

Condenser may be dirty.

The air flow to the ice maker

may be obstructed.

The ambient temperature

and water temperature are

high, or machine is near

some heat source.

Clean the condenser.

Check the installation.

Water is leaking from the unit.

A few water drops fall to the

floor when you open the door

to take out ice from storage

bin.

Water supply connection

leaking.

Normal condensation on the

door or some water together

with ice. Take care when you

take out ice.

Tighten fitting. See “Connect-

ing the Water Line”.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Maxx Ice MIM50-O Instrukcja Użytkowania i Eksploatacji Strona 19

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kostkarki do lodu Maxx Ice MIM50-O